How to Measure Hydraulic Fittings

best hydraulic adapter manufacturer
4 Types Hose Fittings Types you need to know
22nd August 2019
best hose fittings manufacturer

To ensure that the right hydraulic fitting is used, has become a science. It is a method that every hydraulic adapter manufacturer has studied. Here is a five-step process for hydraulic fittings measurement:

Step 1: Measurement of Length

This is the most natural step. All that is required is to describe the length related to hydraulic fitting. The length can be measured with a tape with a keen eye. Lay the fitting on the table. Now stretch the tape across the top of the table to determine the length.

Step 2: Detect the Outside Diameter

Evaluating the outside diameter of any hydraulic fitting is a complex process. The process has a few steps which involve the regular use of calipers:

  1. First, you have to slide the caliper’s top screw till the front of the equipment, making it zero.
  2. Then the calipers should be placed on the outside of the fitting. The jaws now should slowly open so that the fittings adjusts between the jaws.

Once the fittings are set between the jaws, gently close the calipers so that each jaw is holding (touching) the outer side of the fitting.

  1. The digit on the top scale, where the first mark falls in between two marks, should be noted carefully
  2. In the end, the digit on the bottom scale, that should be aligned perfectly with the mark on the sliding scale. The scale should be added to the end of the top scale digit

Step 3: Find the Diameter’s inner side

The process dedicated to inside diameter is very similar to that of measuring outer side diameter. Although, the jaws of caliper are kept inside the fitting. Then the formula described above is the same.

Step 4: Determining the Gauge’s Thread

To determine the gauge thread, the hose fittings manufacturer or distributor of hydraulic fitting will place a pitch gauge on the fitting’s threads. The pitch gauge’s teeth which fit cleanly into the threads emulate the size of the thread gauge.

Step 5: Angle Determination

In the end, every tip of the protractor is put on the angled fitting, with the tip at the center position on each portion. The degree of protractor gives the fitting’s angle.

Last Word

Proper measurement given by hydraulic adapter manufacturer can be deciding between a functioning system and a system which is faulty or leaky. The most foolproof way to guarantee accurate fitting measurement is to take help from a seasoned hydraulic or hose fittings manufacturer.

Leave a Reply

Your email address will not be published. Required fields are marked *